Installing Pond Liner

Teemingtank

Active Member
View Badges
Joined
Nov 22, 2018
Messages
311
Reaction score
187
Rating - 0%
0   0   0
Hi everyone, I’m making this thread in regards to a project I’m working on. I’ve recently framed out a “lagoon” style box and installed the liner. I was curious if I could get some feedback on how the liner is fitting at the corners after my installation. I’ve got some 4x4’s on the interior of the frame and I’m a bit concerned of how the liner will stretch/form around those under water pressure. If the post gains some traction, I will post some photos and explain further. :)
 

Johnd651

Getting back in after 10+ years
View Badges
Joined
Oct 29, 2019
Messages
2,053
Reaction score
2,653
Location
Utica, NY
Rating - 100%
1   0   0
I've used pond linear before outside and it seems to have some stretch into holes and cracks. I'm not sure but would think it would be within the stretch
 
Upvote 0
OP
OP
Teemingtank

Teemingtank

Active Member
View Badges
Joined
Nov 22, 2018
Messages
311
Reaction score
187
Rating - 0%
0   0   0
I know it’s not exactly eye appealing, but I did my best to fit this thing loose, and it’s also not finished yet ;) Where my fingers are pushing in the corner is where i am concerned. You can’t press the liner all the way to the corner
 

Attachments

  • image.jpg
    image.jpg
    103.6 KB · Views: 33
Upvote 0

Dom

Full Time Reef Keeper
View Badges
Joined
Apr 29, 2016
Messages
6,449
Reaction score
6,945
Location
NY
Rating - 0%
0   0   0
I know it’s not exactly eye appealing, but I did my best to fit this thing loose, and it’s also not finished yet ;) Where my fingers are pushing in the corner is where i am concerned. You can’t press the liner all the way to the corner
What is under the liner?

I would sand under the liner to fill voids like this.
 
Upvote 0

gignet01

New Member
View Badges
Joined
Oct 25, 2024
Messages
2
Reaction score
0
Location
quebec
Rating - 0%
0   0   0
how did this turnout ? im doing basicaly the same thing but i was thinking about putty-ing the corners under the liner and also what do you guys think about my design ? its only to the drawing stage rn, it would be a saltwater frag pond 48inch high but only 12 inch deep of water since coral frags dont need lot of water.. this would be a 4x8ft
 
Last edited by a moderator:
Upvote 0

TOP 10 Trending Threads

Back
Top