Hello all !
I've got 125 L (33g) reef tank, whit sump (about 15g).
I wanna build my ATS whit my 3D print.
In my country this filter method is not common used.
So i've no idea of the Mesh dimension. Something like 8 inch square could be ok ?
Since i'd print the mesh, are little square, on the mesh, of 2 mm good ?
I know could be better buy the mesh, but i've found it only in amazon, for 12€...
Reason why i wanna try to print its.
If it works, i'll share whit you stl files for surely !
I've got 125 L (33g) reef tank, whit sump (about 15g).
I wanna build my ATS whit my 3D print.
In my country this filter method is not common used.
So i've no idea of the Mesh dimension. Something like 8 inch square could be ok ?
Since i'd print the mesh, are little square, on the mesh, of 2 mm good ?
I know could be better buy the mesh, but i've found it only in amazon, for 12€...
Reason why i wanna try to print its.
If it works, i'll share whit you stl files for surely !