Hi all, see my build thread for background if you want
This is about removing the hinges attached to the biocube ( the lid is already removed ).
I am trying to think of the best way to get my skimmer to fit, and this hinge is the only thing getting in the way for placing in chambers 2 and 3 :
I figured a hack saw or something, with a friend running a vac to grab the plastic before it drops into my tank.
Here is the skimmer :
So intake would be in chamber two after water goes through my intank media trey. Output would be directly into chamber three. I have an ATO system I will need to figure where to place as well.
The other other concern I have is my return pump... the octo has a higher turnover in GPH. The chambers 2 and 3 are "level-ish" only a small sponge between them. So in theory, would the octo just retain the same level in those back two chambers?
Thanks
This is about removing the hinges attached to the biocube ( the lid is already removed ).
I am trying to think of the best way to get my skimmer to fit, and this hinge is the only thing getting in the way for placing in chambers 2 and 3 :
I figured a hack saw or something, with a friend running a vac to grab the plastic before it drops into my tank.
Here is the skimmer :
So intake would be in chamber two after water goes through my intank media trey. Output would be directly into chamber three. I have an ATO system I will need to figure where to place as well.
The other other concern I have is my return pump... the octo has a higher turnover in GPH. The chambers 2 and 3 are "level-ish" only a small sponge between them. So in theory, would the octo just retain the same level in those back two chambers?
Thanks