Does this graph look like a failing pH probe?

[Downfall]

I've recently started dosing kalkwasser into my system, so I'm paying more attention to pH than I previously did.

I recalibrated the probe 3-4 days prior using 7 and 10 sachets. The probe itself is a little over 2 years old.

The dip on sep 5th happened during my feed cycle, the only thing that happened was my return pump and skimmer turned off for 7 mins and then turned back on. Same for sep 6th, suddenly it seems to be working again after a feed cycle...

 

[Randy Holmes-Farley]

The very fast changes on Sep 5 and 6 look like electrical interference. Did anything else turn on or off at those times?

 

[Downfall]

The very fast changes on Sep 5 and 6 look like electrical interference. Did anything else turn on or off at those times?

Just my varios 2 return pump and my 110sss skimmer.

 

[dank.reefer]

Usually when my PH probe starts whacking out the readings just steadily start climing or dropping over the course of a few days or so. I will verify the actual PH with a PH pen and if it doesn't jive I clean and calibrate the probe. If still no jive then it is time for a replacement.

 

[Downfall]

Hmm

If it's electrical interference, how far away should the pH probe wiring be from power cords? Currently today they're all bundled together.

 

[Downfall]

Unfortunately I don't have a pH pen. Any good recommendations for one that's durable?

 

[dank.reefer]

Unfortunately I don't have a pH pen. Any good recommendations for one that's durable?

I use this Apera PH Pen Apera Instruments they are the company that acrually makes a lot of the probes used for our controllers.

AI311 Premium Series PH60 Waterproof pH Pocket Tester Kit, Replaceable Probe, ±0.01 pH Accuracy, Lcd display https://a.co/d/2o4ML4S

 

[dank.reefer]

Hmm

If it's electrical interference, how far away should the pH probe wiring be from power cords? Currently today they're all bundled together.

Usually the interferance is actually EMF or stray voltage traveling through the water. It could be a power spike from a pump motor or heater kicking on.

 

[Randy Holmes-Farley]

Hmm

If it's electrical interference, how far away should the pH probe wiring be from power cords? Currently today they're all bundled together.

I’d try turning likely things on and off and see if you detect an issue.

It may be the bundled cords. Folks see such issues with the Pinpoint that go away with the same device on battery.