Automated Kalwasser Dosing

Jack20120

New Member
View Badges
Joined
Jan 30, 2023
Messages
19
Reaction score
4
Location
Centreville
Rating - 0%
0   0   0
I'm setting up an automated daily dose of saturated kalwasser solution and would like to get some feedback from those who already do this. I know people use it in their ATO. My evaporation rate is around 1800 ml/day. So maybe dose at 900 ml/day? I'd add automatic controls to kick off if the pH goes too high. FWIW, I'm running DI water from my DOS to a mixed vessel that overflows to my return pump charging tank.
 

anthonymckay

Active Member
View Badges
Joined
Sep 23, 2021
Messages
426
Reaction score
433
Location
California
Rating - 0%
0   0   0
I dose based on my Alk uptake. I run an Alkatronic that's taking measurements every 4 hours. If I see my values are trending downwards after a few days, I increase my kalk dosing. If I see it trending upwards I decrease it. After some tweaking you'll find a happy spot that keeps it in a general desired window (for me anywhere between 8-8.5 is good. I make sure to keep it less than what my evaporation rate is, but that doesn't drive my dosing amount.
 

flyfisher2

Valuable Member
View Badges
Joined
Jan 30, 2012
Messages
1,764
Reaction score
2,834
Location
Central Florida
Rating - 0%
0   0   0
I need to clarify my previous post.
Kalkawasser is not enough for my system so in addition I dose 2 part.
Any adjustments needed in order to maintain the Alkalinity I maintain is done with the 2 part.
 

Randy Holmes-Farley

Reef Chemist
View Badges
Joined
Sep 5, 2014
Messages
72,100
Reaction score
69,741
Location
Massachusetts, United States
Rating - 0%
0   0   0
I'm setting up an automated daily dose of saturated kalwasser solution and would like to get some feedback from those who already do this. I know people use it in their ATO. My evaporation rate is around 1800 ml/day. So maybe dose at 900 ml/day? I'd add automatic controls to kick off if the pH goes too high. FWIW, I'm running DI water from my DOS to a mixed vessel that overflows to my return pump charging tank.

Sounds like a fine plan to me. I'd personally set the pH limit at about pH 8.55.

What size aquarium?

In my tank, half of the evaporation would not have met alk and calcium demand, but by ATO replacing all evaporated water it did. You may need to up the daily amount, depending on the demand.
 

arking_mark

2500 Club Member
View Badges
Joined
Mar 2, 2016
Messages
2,607
Reaction score
1,827
Location
Potomac
Rating - 0%
0   0   0
I'm my opinion, using at ATO with Kalkwasser is a recipe for disaster. Many aquarist have stories about accidentental overdosing using this method.

In my tank, I use a doser set to drip kalkwasser into the tank. With a slow drip, you get a very consistent pH boost. Many just run their drip at night to better level the pH swings.

My tank is typical for evaporation, with about 1 to 1.5% evaporation depending on the season. So I drip ~1% volume per day of Kalkwasser through the doser. This provides roughly 1dKH and a 0.1ph boost (more like 0.08).
 
Back
Top