OP
OP
The Mediocreef
- Build Thread
- Thread starter Mschmidt
- Start date
- Tagged users None
OP
OP
Got home last night too a wet rug in front of the reef.
The e drain 1 was spraying through a small gap.
Got what I could cleaned up . Good thing it's not raining for three next week.
Would have been a great opportunity to use this.
The e drain 1 was spraying through a small gap.
Got what I could cleaned up . Good thing it's not raining for three next week.
Would have been a great opportunity to use this.
LadyMac
Freshwater sage fish whisperer
Looks like what’s all on the back of my rock in the tank, which was said to be sponge and safe.
I’m no expert though so….
I’m no expert though so….
OP
OP
Thought it might be the way it's growing. It's in my overflow box so as long as it stays out of the drain I'm good with it.
tbrown
Nominated Cronie Intern - Might be failing?
I dunno... I have a red sponge that may have killed an Acro. It was growing up the base, then the Acro died, then the sponge covered it. Could just be a coincidence since it seems most of my Acros are doing poorly...
OP
OP
Haven't seen anything like it in the tank though. Just the overflow.
tbrown
Nominated Cronie Intern - Might be failing?
Mine tends to stay in th extreme dark places in the tank. Except that one acro.
OP
OP
tbrown
Nominated Cronie Intern - Might be failing?
Unclog the nozzle probably?
tbrown
Nominated Cronie Intern - Might be failing?
I could be wrong though. It just looks like a clogged nozzle or eSteps.
stoney7713
10K Club member
What material? What are the nozzle temps? In a way it looks like the heat is too low, no layer adhesion, dragging the filament apart.
OP
OP
It extruded fine when it wasn't printing. That was the first thing I looked at.
Petg, 240 no cooling. I can crank it, but should be ok there.
It was after a few tpu prints, that may have caused some sticking. Not sure.
Got the same thing going now with pla, 200 maybe cooling, didn't look. And it's fine.
Similar threads
