Hi, I’ve just made a massive mistake on my apex, I set my doser to on instead of auto and dumped 200ml of Randys diy nitrate recipe into my 40 gallon tank by mistake, instantly increasing my nitrate level up from 5 mg/L to over 200 mg/L.
It took me a few minutes to realise my mistake when I heard the doser pumping as I didn’t realise it was being dosed and unfortunately when I realised it was too late.
Luckily I had 12 gallons of Ro water stored up which I immediately mixed up and replaced. My Hanna meter is flashing at 75. I have done 4 x 4 gallon further water changes but my Hanna is still flashing 75.
It takes me 30 minutes to make 3 gallons of ro water and at this rate it’s going to take a lot of water to get my nitrate back down again.
Should I simply use tap water to get my nitrate down and then deal with the phosphate later? I live in the uk and it’s currently 11pm. My LFS has nutrisea water so I can go and get ready mixed salt in the morning.
If anyone has any advice it will be very much appreciated, thanks.
It took me a few minutes to realise my mistake when I heard the doser pumping as I didn’t realise it was being dosed and unfortunately when I realised it was too late.
Luckily I had 12 gallons of Ro water stored up which I immediately mixed up and replaced. My Hanna meter is flashing at 75. I have done 4 x 4 gallon further water changes but my Hanna is still flashing 75.
It takes me 30 minutes to make 3 gallons of ro water and at this rate it’s going to take a lot of water to get my nitrate back down again.
Should I simply use tap water to get my nitrate down and then deal with the phosphate later? I live in the uk and it’s currently 11pm. My LFS has nutrisea water so I can go and get ready mixed salt in the morning.
If anyone has any advice it will be very much appreciated, thanks.