That's weird. Is there a reason you are using a timer to run a macro to run a dosing pump, and not using the dosing pump menu? Maybe something with the macros is hanging, but I don't know, just guessing at this point
Honestly when Ive had problems like this I restart my Computer. If that doesn't fix it I remove the settings and start over.
Can you share the reef-pi log? dont delete whole reef-pi database, just delete the temperature controller and create a new one if nothing else workHi,
Weird problem. After updating from 3.0 to 4.1 I'm unable to change any temperature settings.
Everything works ok with previous settings but I can't change anything under temp tab.
No matter if I change check frequency (even by 1 second), chart min/max, thresholds - any change = "The temperature settings cannot be saved due to validation errors. Please correct the errors and try again."
Anyone got an idea how to solve this issue?
I could probably fresh install reef-pi but that's an 2 hour work to set up everything back.
Everything else: equipment, lights, ATO works like a charm.
Thanks!
Looks like it should work, that's as close to an all in one package you'll get. In reef-pi set the frequency of the PCA9685 above 1000 Hz as this say it wants 1000-3000 input. 1526 is the limit for PCA9685.
Hi Phil, as I mentioned I tried to get something like this working but got the same results as you, maybe someone has an idea to try?
Do you think that will cause any problems with dosing pumps?? I'm also going to run pumps off of the PCA9685. That and led lights
If you're driving a mosfet or something similar for dosing pumps it should be ok at any frequency, you'll likely see a slight difference at the lowest levels. If you run the light 0-10v module under 1000 Hz the light may start flickering, you'll know if there's an issue but everything should be ok.
do you have one shot enabled?
