Ph probe and Temp link to Easy IOT Cloud

[wacky123]

Ph Temp Probe is used to detect PH and Temperature in a aquarium / fish tank, the code will also create a EasyIoT entry on the cloud.

3D plastic cover decrease the flow of water for more accurate reading.

3D DIY print cover:

Ph probe cover and link to Easy IOT Cloud by wacky123

Ph Temp Probe is used to detect PH and Temperature in a aquarium / fish tank, the code will also create a EasyIoT entry on the cloud. 3D plastic cover decrease the flow of water for more accurate reading. code:https://github.com/frossty/Ph_Temp_Prob Tools: PH probe with BNC...

www.thingiverse.com

code:

frossty/Ph_Temp_Prob

Ph Temp Probe. Contribute to frossty/Ph_Temp_Prob development by creating an account on GitHub.

github.com

Tools:
PH probe with BNC converter:

2.8US $ |Liquid PH Value Detection detect Sensor Module Monitoring Control Board For Arduino BNC Electrode Probe Controller|Integrated Circuits| - AliExpress

Smarter Shopping, Better Living! Aliexpress.com

www.aliexpress.com

ESP8266:

1.41US $ 5% OFF|Wireless module NodeMcu v3 CH340 Lua WIFI Internet of Things development board ESP8266 with pcb Antenna and usb port for Arduino|Integrated Circuits| - AliExpress

Smarter Shopping, Better Living! Aliexpress.com

www.aliexpress.com

Easy IoT could account :

Home

Raspberry Pi, Arduino, internet of things playground

iot-playground.com

 

[SPR1968]

Bump

 

[Elson26]

Nice DIY!

 

[wacky123]

Schema diagram of the prob on a ESP8266
Note: i used a reverse LED which provided 1.4M Ohms

 

[wacky123]

Few more pictures of the connecting wires

 

[Asmolupers]

Few more pictures of the connecting wires

How did you get around the electrical noise problem? I tried this exact ph probe setup and it was incredibly unstable. I ended up switching to atlas scientific and it works flawlessly.

 

[wacky123]

How did you get around the electrical noise problem? I tried this exact ph probe setup and it was incredibly unstable. I ended up switching to atlas scientific and it works flawlessly.

I didn't notice any problem with electrical noise, just had to use a very large resistor on ESP8266 to get the voltage down to 2.5V on A0 (analog), i my case reverse LED worked.
I did had a problem with the Probe sensor it was too sensitive and even slightest movement of water gave inconstant readings, the 3D printed cover stabilized the flow around the probe sensor and code takes a sample of 10 readings, sorts and takes the middle readings.

so far the results has been consistent and stable .... im not sure about the accuracy but it gives a good idea about the swings and flows of the tank.