Trouble connecting IceCap Gyre to Hydros controller

Gregg @ ADP

Valuable Member
View Badges
Joined
Sep 20, 2018
Messages
1,246
Reaction score
3,091
Location
Chicago
Rating - 0%
0   0   0
Hey everybody,

I have a new IceCap 4K gyre that I can’t get connected to the Hydros controller. When I go to set it up, the only options it go es me as an output is either Flow Pump or Alert.

I’ve set these up before and know there is an output option for wave gyre with all the different wave options (sine, square, etc). That option came up for me once, but now I can’t seem to get back to that.

1lpsHxe.jpeg


Any ideas? Of course, every YouTube video out there is 4 years old, and the CoralVue troubleshooting doesn’t help with this.

Thanks.
 
OP
OP
Gregg @ ADP

Gregg @ ADP

Valuable Member
View Badges
Joined
Sep 20, 2018
Messages
1,246
Reaction score
3,091
Location
Chicago
Rating - 0%
0   0   0
It gives me the IceCap 4K option in the Pump Model menu, but it’s not go into me the wave gyre options.

And the gyre isn’t functioning at all.

I also did a hard reset w/magnet.

Any ideas?
 
OP
OP
Gregg @ ADP

Gregg @ ADP

Valuable Member
View Badges
Joined
Sep 20, 2018
Messages
1,246
Reaction score
3,091
Location
Chicago
Rating - 0%
0   0   0
OK, I just essentially pushed a bunch of buttons, and was able to override something…not sure what.

I set it to run between 50%-100%. Not sure exactly what program it’s on, because it is definitely switching flow output, seemingly on a random pattern.

So, better than nothing…but I still need to be able to get that wave gyre tile open to actually program it.
 

Asm481

Active Member
View Badges
Joined
Jul 23, 2022
Messages
185
Reaction score
164
Location
Kenosha
Rating - 0%
0   0   0
I just got the 4k gyre myself. I accepted the flow pump and gyre settings are available in the schedule tab.
 

n2585722

2500 Club Member
View Badges
Joined
Jun 17, 2013
Messages
3,957
Reaction score
2,267
Location
Cedar Park, Tx
Rating - 0%
0   0   0
Hey everybody,

I have a new IceCap 4K gyre that I can’t get connected to the Hydros controller. When I go to set it up, the only options it go es me as an output is either Flow Pump or Alert.

I’ve set these up before and know there is an output option for wave gyre with all the different wave options (sine, square, etc). That option came up for me once, but now I can’t seem to get back to that.

1lpsHxe.jpeg


Any ideas? Of course, every YouTube video out there is 4 years old, and the CoralVue troubleshooting doesn’t help with this.

Thanks.
Once you get your output for the pump setup. You will need to create a schedule from the left menu. The type would be flow pattern. It then let you choose a pattern the maximum flow rate and set the number of pump and select the pump outputs you want in the schedule. You can use one schedule if you set it to run a 24 hour time frame are use multiple schedule through out a 24 hour time frame.
 
Back
Top