Can confirm, that bug still exists. I can provoke it by going the Configuration->Admin->reload route. Usually goes away after a few hours for me.Also Temp isue with occilating houres nog fixed in 3.5?or do i need to purge something first?
Yes. This works too. Encapsulated in epoxy my first lower cost non water proof probe lasted a long time. Recently failed after dropping connector end in salt water several times. And connector corroded.
My suggestion is to find a build thread of someone that has similar goals and skills as you.
Not exactly. You can turn it off directly, since any pwm output can be an outlet, but nothing that will make it more fine grained % based. This will be some work, to come up with a control mechanism that instead of a boolean on/off , take a more nominal approach (% of fractional). The design has to address both control mechanism as well as what part of that algorithm should be customizable by end users.
Dont read this thread to build your controller. As mentioned in the very first post, go through the guides, that will give you some idea, then start a thread if you have specific questions.
Any 2 part clear epoxy should be fine. I used a product from total boat that I originally purchased for building snow skis and snowboards. It’s high end but for this purpose high end isn’t needed. Just make sure the whole probe is submerged in epoxy. You don’t pour it around. You hang the probe into a mold and fill the mold with epoxy. I used a piece of pvc pipe as my mold and wax as a mold release.
reef-pi uses a common driver framework called HAL, which makes it easy to add new driver. This should be fairly easy to integrate, but it requires some coding.
