Red Sea DIY lid kits

[kerbfish]

Trying to figure out what accessory kits I would need for my Red Sea 625 xxl.

I have 3 AI lights that came with. But one is mounted over the overflow box.

they have ways to build around overflow box, but instructions for my model say it goes over the top of my overflow with a gap for the light attachment. Although the over flow box lid has that pop up section of the lid to accommodate the light bracket....not sure if zig zag kit is made for something that wide ?

According to chart I need 3 zig zag kits for 3 lights..sound right? Must have to go get over flow according to recommendations. Or else I would use the kit included in cover and 2 additional kits.
Also I may want to add an apex auto feeder.....what kit for that ?

any tips would be helpful. Not sure be way to cut frame as well or how precise measurements need to be.

Meter box?

 

[dmy535]

I did the kit and cut around the overflow, so needed to measure and cut. I did need to purchase an add on “zig zag” corner piece kit from BRS for like $6 to make the turns I needed

 

[kerbfish]

I did the kit and cut around the overflow, so needed to measure and cut. I did need to purchase an add on “zig zag” corner piece kit from BRS for like $6 to make the turns I needed

Do you have the AI lights mounted on your tank? Did you use additional kits for those ? I have 3 on my tank .

 

[dmy535]

I have 2 radions mounted on mine. Used the RMS arm mounts that attach to back glass. Had to get the extra zig zag kit that gave me enough to go around the mounts and the over flow.