Hey guys, I need some help.
I have an Apex EL and just found it has no power. I do not have a separate power supply to test the base unit but when I pull up fusion I get the following errors.
Since my base unit is powered by the EB832, I think my EB 832 is what went bad.
I can unplug the 832 and plug it back in. I essentially get what I liken to a power flash. Everything (even stuff that isn’t “scheduled” to be on) turns on for about 1-2 seconds and then the whole thing “trips” and powers off.
The reset breaker isn’t “popped.” This whole unit is far outside of warranty so I haven’t contacted Neptune but does anyone have any thoughts? I’ve tried searching but didn’t find much unless I’m using the wrong terminology.
I think I first need to get a power supply for the base unit to see if that will power up. Anyone have an Amazon link for an auxiliary power supply?
I have an Apex EL and just found it has no power. I do not have a separate power supply to test the base unit but when I pull up fusion I get the following errors.
Since my base unit is powered by the EB832, I think my EB 832 is what went bad.
I can unplug the 832 and plug it back in. I essentially get what I liken to a power flash. Everything (even stuff that isn’t “scheduled” to be on) turns on for about 1-2 seconds and then the whole thing “trips” and powers off.
The reset breaker isn’t “popped.” This whole unit is far outside of warranty so I haven’t contacted Neptune but does anyone have any thoughts? I’ve tried searching but didn’t find much unless I’m using the wrong terminology.
I think I first need to get a power supply for the base unit to see if that will power up. Anyone have an Amazon link for an auxiliary power supply?