Hydra 26 Non HD - Power Button / Status Light Ribbon Cable Failure
- Thread starter JArnold
- Start date
- Tagged users None
Dream54ing
Active Member
- Joined
- Apr 25, 2017
- Messages
- 130
- Reaction score
- 75
following... I had 5 that stopped working after replacing the burnt lens. only thing that I touched was the ribbon cable.
So I have basically required it… ordered new cable, put in a reset button, added a smd diode… but I still cannot get it to connect to the controller. Documentation is almost impossible to find. I am using the old wireless controller .. I believe it was version 2… not the one with rubber buttons. I have tried channels 1-10 and still get nothing. I am assuming that the module that powers this connection has failed over time.
Dream54ing
Active Member
- Joined
- Apr 25, 2017
- Messages
- 130
- Reaction score
- 75
where and what new cable did you order? the power ribbon cable (touch membrane)? all 5 of mine wont even turn on...
Sounds like you might have a wifi chip issue, which no replacement parts for. Typically the entire board needs to be replaced, which is also no longer available anymore.
Sounds like you might have a wifi chip issue, which no replacement parts for. Typically the entire board needs to be replaced, which is also no longer available anymore.
Similar threads
