Help, Apex feed mode program with Hyrdos WaveEngine2 & APX Link cable

OP
OP
BryanM

BryanM

Active Member
View Badges
Joined
Jun 27, 2024
Messages
277
Reaction score
230
Location
Morgan Hill
Rating - 0%
0   0   0
FYI, this is resolved.

For anyone that runs across this:

1) CoralVue support was very helpful, and resolved this over the phone in about 10 minutes.
2) In the outputs, selecting a powerhead, there's a dropdown "Active in modes", where you can select 3 things: Feeding, Normal, Water changes.

For some reason all 3 were selected. Basically preventing anything from changing, since I told it that they powerheads were to always be on.
 

n2585722

2500 Club Member
View Badges
Joined
Jun 17, 2013
Messages
3,957
Reaction score
2,267
Location
Cedar Park, Tx
Rating - 0%
0   0   0
FYI, this is resolved.

For anyone that runs across this:

1) CoralVue support was very helpful, and resolved this over the phone in about 10 minutes.
2) In the outputs, selecting a powerhead, there's a dropdown "Active in modes", where you can select 3 things: Feeding, Normal, Water changes.

For some reason all 3 were selected. Basically preventing anything from changing, since I told it that they powerheads were to always be on.
The outputs usually default to active in the different modes when created so you will need to uncheck them in the modes you do not want them active in. You can also set this in the settings for the modes as well and the individual output settings.
 
Last edited:
Back
Top