blaxsun
10K Club member
- Review score
- +0 /0 /-0
Hospitality Award
Build Thread Contributor
August 15. 50 Under PAR
So I've been reading about a few "quirks" with the new Neptune AOS update to 5.10 8A22, and was hoping (crossing fingers) that nothing on my system would be affected. I should've held off on this update - but the alarm in the Apex control panel was triggering my OCD...
I guess the folks at Neptune needed to run put this particular update through its paces more as it's basically skewed my PAR readings. Normally I'll see a curve throughout the day in the 125-150 range. Now it only reads the baseline setting of 50.
Affected modules (thus far) appear to be the PMK and flow meters. I've got a support ticket in to Neptune - but I suspect I'm going to have to patiently wait for a fix along with everyone else.
So I've been reading about a few "quirks" with the new Neptune AOS update to 5.10 8A22, and was hoping (crossing fingers) that nothing on my system would be affected. I should've held off on this update - but the alarm in the Apex control panel was triggering my OCD...
I guess the folks at Neptune needed to run put this particular update through its paces more as it's basically skewed my PAR readings. Normally I'll see a curve throughout the day in the 125-150 range. Now it only reads the baseline setting of 50.
Affected modules (thus far) appear to be the PMK and flow meters. I've got a support ticket in to Neptune - but I suspect I'm going to have to patiently wait for a fix along with everyone else.