I took out jebao 150 gyre pump and replaced it with two scp-180 ( rated for 6700g-9600g ) at full power on both side, it’s moving my water like crazy, and I added another scp-120 in the middle to eliminate any dead spot.
Here’s my backyard ro waste container for backyard watering and other tanks.
As you can see I started an outdoor macro algae grow tank, hopefully they would survive the temperature swing during day and night.
Instead of filter socks, I have this 1” thick mesh pad for water that comes out of my tanks, so to collect large particles. I once had a nem landed on the pad. Below the pad is the skimmer intake.
My rodi waste also goes to fill my outdoor pond, filled by using float valve. Did diy filter with salt bucket and left over plumbing. UV is on the way. Hopefully water will clear up soon.
Now that I have a CBB that just eliminated all my pest in my tank, I feed it aiptasia off some of my frag tricks. But most are gone too... now I need to set up a small stress free tank just to grow aiptasia, maybe I will just use that outdoor plant tank in my backyard
Another blow, I’m 5 for 5 with red dragon. This time I tired it in low light low flow and high flow with two frags, still bleached. I’m done with this coral.
Upgraded Apex EL to the full Apex, took a few tries to get it right. If i have to do it again, I could do it in less than a minute.
Next up, swapping out all probes with new one ( calibrate ) and add additonal temp probe for ambient temp, additional ph probe for CarX
I replace the main Apex brain, and I made screenshot of each power port setting i had and copied over the old settings. I made the mistake by resetting the brain without connecting all the probes and the powerbar.