I have problems with surface film if I don't use that clear weir that spreads out the water intake to make it flow faster at the top. But unfortunately that raises the water level a little higher than I'd like. I'm thinking about making a custom return for it that's even wider and a bit lower.
Aquatop Recife ECO 40 gallon
- AIO Build
- Thread starter Krishna Ramaraju
- Start date
- Tagged users None
Jers_Reef
New Member
Hey all! Fellow Recife 24 owner here. Great stuff here wrt floss hanger boxes in chamber 1. Need to get something like that going vs. currently scrunching some sponge above my heater to hold up my floss. Causes water level to fluctuate as it takes up gunk.. Not a long term config. But! I did want to share one upgrade/mod that I’m pretty proud of that you all might consider.
If interested in adding more carbon and/or gfo media reactor to lower phos, there’s just enough room in the return chamber to fit a Sicci 1.5 with the stock return pump! I went with the brs-gfo-carbon-reactor-5-single, comes with the pump and a valve for $85. I use 2 18” “Orbit Flex Riser” hoses to send and return to and from chamber 4, with wall mounted shut off valves right above my tank (other options, you wouldn’t have to drill into wall to mount valves, but I’m in the basement so nbd). Standard flex hose with push fittings run from valves to canister. No leaks after ~6 months with this config!The leap of faith comes when you cut down the stock rigid return stem and then set the stock return right above the sicci 1.5. The siici send line can run right around the main return, and canister return dumps in right where display return picks up.
It’s a bit tight but totally works, and really knocks down the phos. I feed corals daily (alternate oyster feast, Reef Roids, AB+), and still maintain <0.15ppm with only about 2TBSP gfo (don’t add more or you will bottom out!). I do need some type of better flow reducer on the return, since it throws up a decent wave after shortening the throw.. All good fun!
If interested in adding more carbon and/or gfo media reactor to lower phos, there’s just enough room in the return chamber to fit a Sicci 1.5 with the stock return pump! I went with the brs-gfo-carbon-reactor-5-single, comes with the pump and a valve for $85. I use 2 18” “Orbit Flex Riser” hoses to send and return to and from chamber 4, with wall mounted shut off valves right above my tank (other options, you wouldn’t have to drill into wall to mount valves, but I’m in the basement so nbd). Standard flex hose with push fittings run from valves to canister. No leaks after ~6 months with this config!The leap of faith comes when you cut down the stock rigid return stem and then set the stock return right above the sicci 1.5. The siici send line can run right around the main return, and canister return dumps in right where display return picks up.
It’s a bit tight but totally works, and really knocks down the phos. I feed corals daily (alternate oyster feast, Reef Roids, AB+), and still maintain <0.15ppm with only about 2TBSP gfo (don’t add more or you will bottom out!). I do need some type of better flow reducer on the return, since it throws up a decent wave after shortening the throw.. All good fun!
Last edited:
jettpeterson
Community Member
I have the same tank all the place I bought from said is that you should replace the light and protein skimmer HAVENT found a fitting skimmer yet but the Kessel A80 is the best light for this aquarium in my opinion
Similar threads
