Seeking directions for dosing Kalk via a dosing pump

pledosophy

Active Member
View Badges
Joined
Jul 21, 2009
Messages
379
Reaction score
267
Location
Long Beach, CA
Rating - 0%
0   0   0
I am looking to start adding kalk, via a dosing pump to a reef tank. My goal is to maintain a nightly pH and also to maintain calcium, alkalinity, and magnesium needs.

I have read conflicting information as to if a stirrer is needed, or can I just put the mixed kalk water in a 5g jug, and then use a dosing pump to pull from the jug? Some people state you need to keep the kalk in it's own reactor and then pump in fresh water to the reactor and have that overflow to the sump.

I am just looking for a way that works.

I will be using a DOS for the doser if that matters.

The tank is a new 165g and currently uninhabited except for a few snails so great time to figure it out. I would like to add this to my SPS cube later, but thought I would try it on my 165g while it goes through the algae cycles and before I start adding to many corals.

Appreciate the help.
 

Jekyl

GSP is the devil and clowns are bad pets
View Badges
Joined
Jan 15, 2019
Messages
12,484
Reaction score
16,937
Location
Michigan
Rating - 0%
0   0   0
Focus should be on alkalinity and calcium when using kalk, not ph. With a brand new tank I would get accustomed to reading parameters and dosing by hand probably for the duration of the uglies. Which can last up to a year or so.
 
OP
OP
P

pledosophy

Active Member
View Badges
Joined
Jul 21, 2009
Messages
379
Reaction score
267
Location
Long Beach, CA
Rating - 0%
0   0   0
Focus should be on alkalinity and calcium when using kalk, not ph. With a brand new tank I would get accustomed to reading parameters and dosing by hand probably for the duration of the uglies. Which can last up to a year or so.
Forgot to mention, I've been in the hobby 22 years. Not new to dosing, just new to kalk.

Kalk gives that wonderful pH boost at night. I will supplement the rest of Alk and Ca with 2 part. Based on what the tank is evaporating and how much Alk and Ca my other tanks consume I won't be able to keep levels stable with just Kalk alone. My reason for wanting to include Kalk in my regiment if for pH.
 
OP
OP
P

pledosophy

Active Member
View Badges
Joined
Jul 21, 2009
Messages
379
Reaction score
267
Location
Long Beach, CA
Rating - 0%
0   0   0
Agree with Garf, I dose 6.8L of saturated kalk per day from a 58 gallon/220L container that is covered and unperturbed between refills

Here is an article about it I believe written by Randy Holmes: http://www.reefkeeping.com/issues/2005-01/rhf/#5

So your kalk is sitting for a month at a time with no mixing? That is good to hear. Does the dose stay consistent?

Putting a 55g barrel in the garage on the other side of the wall would be very easy for me.

How are you mixing that amount? wooden spoon? :D
 

srit1

Community Member
View Badges
Joined
Jan 29, 2022
Messages
25
Reaction score
28
Location
MA USA
Rating - 0%
0   0   0
Since I pull the doses from ~12 inches/30cm off the bottom I don't let it get all the way empty before adding new rodi from a valve above this container. While this is happening I add the correct amount of kalk tablespoon by tablespoon. I do not mix it at all, just the let the falling water do that then I close it back up for another 2-3 weeks. I have not tested the doeses themselves to know if they are perfectly consistent but alk in the system remains very stable. I made a little spreadsheet to determine how many tablespoons to add based on how much water I am adding to my kalk container:

1666392210175.png


Every spring I let it go low, carry outside and rinse it out. I've been doing this for years now supporting my ~500g system.
 
OP
OP
P

pledosophy

Active Member
View Badges
Joined
Jul 21, 2009
Messages
379
Reaction score
267
Location
Long Beach, CA
Rating - 0%
0   0   0
Since I pull the doses from ~12 inches/30cm off the bottom I don't let it get all the way empty before adding new rodi from a valve above this container. While this is happening I add the correct amount of kalk tablespoon by tablespoon. I do not mix it at all, just the let the falling water do that then I close it back up for another 2-3 weeks. I have not tested the doeses themselves to know if they are perfectly consistent but alk in the system remains very stable. I made a little spreadsheet to determine how many tablespoons to add based on how much water I am adding:

1666392210175.png


Every spring I let it go low, carry outside and rinse it out. I've been doing this for years now supporting my ~500g system.
Beautiful!

As long as the Alk is staying consistent that is a good enough tell for me.

I am hopeful that a 55g barrel in the garage will provide me the same result you have, but maybe last a little longer since my tank is only a third of yours. At 2L a day I could stretch that a very long time.

Really appreciate your time on this.

If I could trouble you for one more detail? How is the longevity of the dosing pump for you? Are you doing anything to clean the heads?
 

srit1

Community Member
View Badges
Joined
Jan 29, 2022
Messages
25
Reaction score
28
Location
MA USA
Rating - 0%
0   0   0
I use 2 heads on my doser for just kalk. The inner tubes wear out 1-3 times per year. I bought replacement tubing on amazon:
3mm ID x 5mm OD Peristaltic Pump Flexible Hose Silicone Tubing Food Grade Tube 3 Meter for 10 bucks or so.

As you only need a few inches, this has lasted years. Depending on your doser, you may need a different diameter. When the tube does fail by the way, it does so very slowly and I will notice that a few drips will get out, go back down the line and then dry out leaving kalk behind. My doser sits right over my kalk container. If you don't catch that immediately it doesn't cause a problem other than a trivially smaller dose.
 
Back
Top