Reef crystals alkalinity

Jrswish

Active Member
View Badges
Joined
Jan 5, 2019
Messages
140
Reaction score
74
Rating - 0%
0   0   0
I thought reef crystals was supposed to have higher alk? Every water change it's at 1.026 salinity with 8.0Alk
 

Reefer Matt

Reef Cave Dweller
View Badges
Joined
May 15, 2021
Messages
6,977
Reaction score
31,412
Location
Michigan
Rating - 0%
0   0   0
I thought reef crystals was supposed to have higher alk? Every water change it's at 1.026 salinity with 8.0Alk
Usually it’s 10.5-11 dkh for me. I have to add an acid to lower it down to 8.5 dkh. What test kit are you using?
 

UMALUM

Well-Known Member
View Badges
Joined
Sep 7, 2023
Messages
800
Reaction score
989
Location
Fl.
Rating - 0%
0   0   0
I've seen it precipitate down to the 8s if mixed to quick or in warm water.
 

UMALUM

Well-Known Member
View Badges
Joined
Sep 7, 2023
Messages
800
Reaction score
989
Location
Fl.
Rating - 0%
0   0   0
If your test kit is accurate your obviously doing something wrong. How are you mixing it and at what temp?
 
OP
OP
J

Jrswish

Active Member
View Badges
Joined
Jan 5, 2019
Messages
140
Reaction score
74
Rating - 0%
0   0   0
77 degrees, and 5 gallon bucket with 0tds ro/di water. I usually mix it for 2 hours
 

twentyleagues

2500 Club Member
View Badges
Joined
Mar 27, 2023
Messages
3,408
Reaction score
3,630
Location
Flint
Rating - 0%
0   0   0
77 degrees, and 5 gallon bucket with 0tds ro/di water. I usually mix it for 2 hours
Is there precipitation on your mixing pump impeller? or heater?
I never had this issue in the past. I would mix up a whole box at a time and keep it heated and moving for about 4-6 weeks. Since I have gotten back in it happens every time I mix a bag if I dont use it within a week or two. My heater gets precipitate covering and my impeller does also. I am ok with it because I have been keeping my tank at a lower dkh 8-9. But near weeks 3-4 the drop is more than that.
 

klc

Community Member
View Badges
Joined
Jul 24, 2021
Messages
82
Reaction score
112
Location
Arizona
Rating - 0%
0   0   0
To be honest I've never check the alk on freshly mixed water. I live in Phoenix and cold water doesn't exist out of the tap for 8 months of the year lol. I just mixed up 30 gallons yesterday and there is always some white scaly residue in my mixing container, I guess this is the calcium precipitation that Randy mentioned. It has never caused any issues with my SPS dominant tanks. I'll have to test the alk the next time I mix water, and maybe even spike it with some 2 part if necessary. Good topic.
 

Randy Holmes-Farley

Reef Chemist
View Badges
Joined
Sep 5, 2014
Messages
72,100
Reaction score
69,741
Location
Massachusetts, United States
Rating - 0%
0   0   0
Shouldnt u temp acclimated the water to match ur tank? or am i wrong

Depends on how you use the water. For small changes in an awc, no heating is needed. If you do bigger changes, you can also wait to heat it until you are ready to use it.
 

robottaway

Community Member
View Badges
Joined
Feb 11, 2019
Messages
92
Reaction score
82
Location
Bakersfiled, CA
Rating - 0%
0   0   0
77 degrees, and 5 gallon bucket with 0tds ro/di water. I usually mix it for 2 hours
Same setup here. I mix about half cup slowly, wait an hour repeat until close then I get out the tablespoon do the same until I am dialed in. I keep the mixing pump on for 24-48 hours and let it all settle in. I always have some crud on the bottom. Dkh 9.8-10 with red sea and api tests.
 
OP
OP
J

Jrswish

Active Member
View Badges
Joined
Jan 5, 2019
Messages
140
Reaction score
74
Rating - 0%
0   0   0
I did a fresh batch of 5 gallons, alkalinity is at 9.6 now! I didn't use a heater at all, I also mixed the salt up a lot in the bucket first! thanks for everyones input.
 
Back
Top