Radon xr15 or orphak icon for 5ft 120Gal

[Jshiloh]

I have not done this but I believe this is how.

1. From the all devices screen select one of the lights
2. Select settings at the bottom
3. Select system settings
4. Under other select the create group option

I think that will work.

Thank you ! This worked.

 

[Jshiloh]

I have not done this but I believe this is how.

1. From the all devices screen select one of the lights
2. Select settings at the bottom
3. Select system settings
4. Under other select the create group option

I think that will work.

I put the lights into a group made a schedule and they were working fine. But I walked into feed and one light was off and other was on. If I do Manuel mode they both work. If I play the schedule they both work but once they run the program at the current time one light turns off.

And ideas would be much appreciated

 

[Jshiloh]

I have not done this but I believe this is how.

1. From the all devices screen select one of the lights
2. Select settings at the bottom
3. Select system settings
4. Under other select the create group option

I think that will work.

 

[Jshiloh]

Light should be on but it's not. Again if I go into quick it works just not on program

 

[Ef4life]

I don’t have the most current version so im
Unfamiliar with that app. Is there a reset button on the light or in the app somewhere you can try?

 

[Jshiloh]

I don’t have the most current version so im
Unfamiliar with that app. Is there a reset button on the light or in the app somewhere you can try?

I finally figured it out that's to darknmighty. For the pairing setting and group them. As far as one of the lights turning off I was going through the app again and noticed the luner setting was turned on that light. I turned it off light went back to the normal program. Moral of the story make sure both luners are turned off or change the times to after your program