Hello everyone I have a question?
I did a par reading on my tank for the first time. I noticed that the par is at 30 on the sand bed and 100 at the top. I’m currently running 1 hydra 26HD on a 9 gallon. Yes I know it’s over kill, but was bought for when I upgrade so I don’t have to buy a new light.
BRS recommends the mounting height to be 13 inches off the surface so I placed mine at 12 which is as high as my mound will go.
My question is I’m adding sps like birds nest and encrusting montipora so I wanna make sure my PAR is more then 100 for them, how should I go about this?
I have already tested what % I need the lights at to reach the 250-450 par range at the top of my tank. Which would cause the sand bed to be 100-120.
Should I be making adjustments now and at what rate? Sps is already put in tank as of yesterday.
I did a par reading on my tank for the first time. I noticed that the par is at 30 on the sand bed and 100 at the top. I’m currently running 1 hydra 26HD on a 9 gallon. Yes I know it’s over kill, but was bought for when I upgrade so I don’t have to buy a new light.
BRS recommends the mounting height to be 13 inches off the surface so I placed mine at 12 which is as high as my mound will go.
My question is I’m adding sps like birds nest and encrusting montipora so I wanna make sure my PAR is more then 100 for them, how should I go about this?
I have already tested what % I need the lights at to reach the 250-450 par range at the top of my tank. Which would cause the sand bed to be 100-120.
Should I be making adjustments now and at what rate? Sps is already put in tank as of yesterday.