Neptune DOS Manual Water change

drjr1861

New Member
View Badges
Joined
Feb 11, 2022
Messages
3
Reaction score
2
Location
Howell
Rating - 0%
0   0   0
I recently hooked up the Neptune DOS and wanted to use the manual water change function through the set up wizard. Everything seemed to work fine through the set up, the virtual outlets were created, I didn't alter them, everything set to AUTO. The issue i ran into was that about 5 or so minutes after finishing the set up process the pumps initiated and started adding/removing water. I didn't push the feed mode button that i had designated or select the water change option at the end of the set up.

I think my best workaround is to use the DoW function to set the DOS to off on all the days except for the day i want the change to take place but i was wondering if anyone had a similar issue with the manual water change function and if there is a fix.
 

Reefing Madness

Carbon Doser
View Badges
Joined
Oct 27, 2012
Messages
19,879
Reaction score
7,115
Location
Peoria, AZ.
Rating - 0%
0   0   0
1729096093294.gif
 

Bartanto

Community Member
View Badges
Joined
Feb 5, 2024
Messages
88
Reaction score
78
Location
Colorado
Rating - 0%
0   0   0
So the task created H2O_start and H2O_control? Would like to see code on both pls! I’d also just run the task again to overwrite whatever you have now.
 

HAVE YOU EVER KEPT A RARE/UNCOMMON FISH, CORAL, OR INVERT? SHOW IT OFF IN THE THREAD!

  • Yes!

    Votes: 32 45.7%
  • Not yet, but I have one that I want to buy in mind!

    Votes: 9 12.9%
  • No.

    Votes: 26 37.1%
  • Other (please explain).

    Votes: 3 4.3%
Back
Top