Mp40 slave

Calireefer92

Well-Known Member
View Badges
Joined
Aug 7, 2018
Messages
636
Reaction score
186
Location
Corona
Rating - 0%
0   0   0
Hey reefers trying to set up my mp40 as a master and slave when I’m trying to set it up it says to hold the mode to enter the configuration as the last step but when I hold it they just stay flashing blue and green and green and yellow any idea how I also reset them before doing it
 

Reef.

2500 Club Member
View Badges
Joined
Mar 12, 2019
Messages
4,843
Reaction score
3,621
Rating - 0%
0   0   0
Use mobius far easier (if you have it that is) )set the main then on your 2nd powerhead click on edit in the big circle and where all the different modes are listed you will see one that says “child” just drag that to the bar and then choose either anti sync or sync anti sync is probably best, your child will do the opposite of the main, when one is fast the other is slow, better that then having both slow at the same time.

Then also set the child to be at a certain percentage of the main, 100% is probably best, as it will then match the power of the main.
 
OP
OP
C

Calireefer92

Well-Known Member
View Badges
Joined
Aug 7, 2018
Messages
636
Reaction score
186
Location
Corona
Rating - 0%
0   0   0
Use mobius far easier (if you have it that is) )set the main then on your 2nd powerhead click on edit in the big circle and where all the different modes are listed you will see one that says “child” just drag that to the bar and then choose either anti sync or sync anti sync is probably best, your child will do the opposite of the main, when one is fast the other is slow, better that then having both slow at the same time.

Then also set the child to be at a certain percentage of the main, 100% is probably best, as it will then match the power of the main.
I can not use mobius on the mp40
 

Reef.

2500 Club Member
View Badges
Joined
Mar 12, 2019
Messages
4,843
Reaction score
3,621
Rating - 0%
0   0   0
This is a good video explaining it.



If you can not get it to work, you can just set both to the same mode, for example Reefcrest then just turn one powerhead off and the other on, then turn it back on when the other powerhead is ramping down, so you have one going up in power when the other is going down in power.
 
OP
OP
C

Calireefer92

Well-Known Member
View Badges
Joined
Aug 7, 2018
Messages
636
Reaction score
186
Location
Corona
Rating - 0%
0   0   0
I was missing the chip I had a replacement controller but it doesn’t have a chip in the new one
 
Back
Top