The synergy V3
Getting a synergy overflow quiet?
- Thread starter OutColdCRNA
- Start date
- Tagged users None
OP
OP
OutColdCRNA
Valuable Member
We have steps in the right direction!!! So much better! I pulled one half of the two 90’s ,on the secondary, off to raise the level. This helped. Then I had the idea to silence the waterfall. The majority of noise is from the overflowing water through the weir. I went to scrounge through my fish box of random stuff to see what I could come up with. I found a sheet of cross stitch fabric that I had used to DIY an algae scrubber in my AIO. Perfect length and width. Disclaimer, do not remove the weir of the synergy while the pumps are running. I did have some overflow onto the floor before I could shut the pumps down.
Anyway, I cut sections of the cross stitch mesh and rolled them up and placed in each of the 4 sections of the inside front overflow box. Whatya know! Not silence, but vastly better than before. I can actually hear the surface breaking from my returns!
Still some dialing in but we are getting there! This overflow design is stupid!! But my wife is much happier!!
Anyway, I cut sections of the cross stitch mesh and rolled them up and placed in each of the 4 sections of the inside front overflow box. Whatya know! Not silence, but vastly better than before. I can actually hear the surface breaking from my returns!
Still some dialing in but we are getting there! This overflow design is stupid!! But my wife is much happier!!
Last edited:
Similar threads
