DIY Questions.....

rcillig

Active Member
View Badges
Joined
Mar 12, 2019
Messages
173
Reaction score
174
Location
Omaha
Rating - 0%
0   0   0
I've only made a few very basic stands to this point. I'm trying to make a step up in quality with this current stand I'm starting. A few questions I want to make the sides removable and was thinking of either dowels or magnets, pros or cons for either? Should I glue and screw the stand or just screws, is there any benefit of doing it one way or the other? Finally, what does everyone think of covering the back of the stand with just a hole for stuff to run through? Will that increase humidity or reduce evaporation?
 

MoshJosh

2500 Club Member
View Badges
Joined
Jan 27, 2022
Messages
3,968
Reaction score
4,419
Location
Grand Junction
Rating - 100%
1   0   0
When making stands with wood I always use screws AND wood glue (Titebond 3 or 2. 3 is supposed to be more water resistant/proof, but I find it stains the wood/is harder for finishing if you don’t clean up squeeze out quickly (maybe I’m crazy)). For removable sides I would probably do magnets for ease of removal and for the fact there is no mechanical connection to fail. My current stand has a sold back with two holes in it. . . Aesthetically I like the look (when the stand is open. . . Which is rare) but it adds some challenges to cord management for sure!!!

Hope that helps!
 

HAVE YOU EVER KEPT A RARE/UNCOMMON FISH, CORAL, OR INVERT? SHOW IT OFF IN THE THREAD!

  • Yes!

    Votes: 32 45.7%
  • Not yet, but I have one that I want to buy in mind!

    Votes: 9 12.9%
  • No.

    Votes: 26 37.1%
  • Other (please explain).

    Votes: 3 4.3%
Back
Top