DIY AI Blade mount help

[DaveC]

Thanks, Funny how they are in stock right after I built mine!!!
The orphek arm adaptation I made is much better in the end.
I cut the clamps off it so it just rests on the edge now. It is convenient.
I can also adjust the height/angle now too.

Always happens like that I do like how you can adjust the angles with yours

 

[bullseyereef]

Just under 6". But I made an adjustment and attached my Primes to the brackets as well. This caused the front to have a slight tilt, but it's not very noticeable.

View attachment 3039791
View attachment 3039793

Did the blade clips come with the blade? Or did you order them separately?

 

[Alsteezy1st]

Did the blade clips come with the blade? Or did you order them separately?

Mine originally came with the low profile tank mounts. I believe the 39 inch + come with the clips. I ordered the clips from BRS.

Blade LED Mounting Clips - Aqua Illumination

A set of two mounting clips for the Blade Smart LED Strip Lights from Aqua Illumination. The clips will hold your Blade firmly onto the AI HMS Single Arm Mount or HMS Hanging Kit rails.

www.bulkreefsupply.com

 

[Bj’s Reef]

I figured it out. Extrusions are really versatile..
I just buy a 10 series to attach the arms to like it is the light. Then I add 2 blocks with m8 holes on the ends to attach on both ends of the blade. Attach the top of those blocks to the rail I made above. Wala I can move it side to side and even spin to angle it.

Can you share a picture of the mount you made. I think it would help a lot of us.

 

[Schulks]

Can you share a picture of the mount you made. I think it would help a lot of us.

I did decide to try it and I ordered the parts. I updated the thread with pictures on page 2 near the bottom in the thread.

You could connect the Blade to the orphek arms in a lot of ways but this is what I did. If I was using the orphek arms for a longer Blade light I would buy the clips from BRS instead of using the m8 mounting holes on the ends.

 

[Schulks]

Can you share a picture of the mount you made. I think it would help a lot of us.

if the other option, with the current arms, will work for you I would go that route. The pictures look really nice but I haven't tried it and mine has it's advantages. If you need it mounted on the sides of the aquarium or if you want to be able to move the bar wherever/however high you want (as long as your lid permits) use the orphek arms. It is sturdy and works. I think it just feels a bit bulky for my 12" blade.

 

[troutbum17]

I don’t mean to pivot this thread, but it seems like there are a fair number of blade owners in this thread. Are any of you all experiencing issues with unbalanced light across the bar, or power cord wire exposure where it connects to the fixture like I’ve seen in some other threads?

 

[flatlander93]

I’m wondering about this too. Obviously there are some problems with these but how widespread is something I want to know too. I really think this is the best light option for my cube. I’d get the Orphek but with a controller they will be quite expensive I think.