Have been running the CRTT for a year. Recently had the main light go red and a beep start. This apparently is due to the controller not getting a flow reading. This can be caused by either a) the flow sensor failing or b) the feed pump failing or c) feed line clog.
My cause was the feed pump. Deltec sent a replacement and it’s back in operation.
If I had to do this over I would verify if the pump works my pressing the mode button for 5 seconds. This will cause it to pump. That should help point you in the right direction.
My cause was the feed pump. Deltec sent a replacement and it’s back in operation.
If I had to do this over I would verify if the pump works my pressing the mode button for 5 seconds. This will cause it to pump. That should help point you in the right direction.
