Can’t keep 25 lagoon AIO return chamber water level up

Northern Flicker

Valuable Member
View Badges
Joined
Apr 22, 2023
Messages
1,832
Reaction score
2,920
Location
In the simulation
Rating - 0%
0   0   0
To me it kinda looks like your ATO sensor is really deep in the middle chamber.

You want it to fill the water high enough that it just barely cascades from the heater chambers into the middle chamber.

I ran this tank with the pump always cranked to its highest so its not a pump issue.
 
OP
OP
J A' mhuir

J A' mhuir

Active Member
View Badges
Joined
May 27, 2024
Messages
141
Reaction score
114
Location
Buffalo
Rating - 0%
0   0   0
To me it kinda looks like your ATO sensor is really deep in the middle chamber.

You want it to fill the water high enough that it just barely cascades from the heater chambers into the middle chamber.

I ran this tank with the pump always cranked to its highest so it’s not a pump issue.
hey, yes indeed it was. I did solve this issue. With adding water to the main Display. Now it’s just about 1/4 inch cascade. Running pump full. I am thinking of switching to two IOAOI Nano Return pumps. See if I can get that extra maybe 70gph.
Thanks for your suggestions!!
 
Back
Top