Calling all Bean Animal experts

[ReefDreamz]

I plumbed my main siphon and open channel drains quite a far ways down into my sumps crash box. The open channel has quite a lot of bubbles coming out. I'm wondering if this is a bad thing and I should shorten these drain pipes closer to the waters surface for 2 reasons, one because this might be contributing to microbubbles in my tank and two because this might be depressing my pH by mixing high CO2 air into the system. Any thoughts?

 

[rwreef]

You should shorten the pipes to be about 1 or 2 inches below the water line. My break animal is perfectly quite and no bubbles which is nice for avoiding salt creep from the bubbles.

Impressive setup btw!

A great video that explains everything

 

[areefer01]

Best idea is to go to the source.

Edit: All (3) standpipes extend into the sump and terminate just below the water level.

Silent & Fail-Safe Aquarium Overflow System | BeanAnimal's Reef

Build the world famous "Bean Animal" silent and fail-safe aquarium overflow system. No noise, no adjustment, no floods. A truly set and forget setup that makes the Durso and Stockman style of standpipes obsolete! Build your own today!

beananimal.com

 

[Syntax1235]

Agree with both comments above. Siphons need to terminate no more than an inch below the water line.

Where did you plumb the gate valve on the main

 

[FSP]

Yes to shortening, 1" below the water level. Better for system operation. Shouldn't do anything about the bubbles though.

Bubbles just mean there's more water going down the open channel than the pipe diameter can handle smoothly. Tune it so more water goes down the siphon and less down the open channel. If you have horizontal runs in the pipe or extremely high flow, you may be stuck with a few bubbles.

 

[ReefDreamz]

Agree with both comments above. Siphons need to terminate no more than an inch below the water line.

Where did you plumb the gate valve on the main

Just above the sump. I put a gate valve on my open channel too just because

 

[Reef - Tripp]

To geo sump.

 

[ReefDreamz]

To geo sump.

I dont understand. Are those slits cut into the drain pipes? If so why? I see yours are equally far down into the crash box as mine are and you also have bubbles.

 

[Syntax1235]

I dont understand. Are those slits cut into the drain pipes? If so why? I see yours are equally far down into the crash box as mine are and you also have bubbles.

I have a bashsea sump and it came with the same pipes with slits. The slits are to disperse the water so it creates a more gentle flow so it does not disturb a refugium. I replaced mine with regular pvc so I could plumb properly.