Glad to help! I’m new too but I figured I could share what I’ve learned so far@Sisterlimonpot @dangles @billyocean @KStatefan just wanted to say a big thank you, for helping me wrap my mind around this!
I pulled then 4 stage out of the floor and put it up in the counter to where I could see it good. It wasn't nearly as difficult as I thought it was going to be. I virtually just disconnected the 3rd canister mixed DI, replaced with a second carbon block. Then plumbed that 3rd block to the Membrane and then plumbed the membrane outlet to the new DI stages.
All is well and 0 TDS. I was already getting 0, but my mixed DI was only lasting about 4 months. I will add the auto flush valve as well, it's on order. Already have the Aquatec booster pump and that's the best $150.00 anyone can spend. It took my pressure from 30psi to a little over 80psi that I adjusted. It would take it higher than that, but I'm good with around 80
Thanks again everyone.
If you’ve already got the booster pump all you need is the auto flush valve. Not the whole auto flush kit, since the booster pump comes with the power supply it needs.
Auto Flush Flow Restrictor - Aquatec
Choose the Aquatec Auto Flush Flow Retrictor that meets your RODI systems flow rate. 300 mL/min 400 mL/min 500 mL/min for 75 GPD single membranes or 150 GPD Water Saver Systems 600 mL/min 700 mL/min 800 mL/min for 100 & 150 GPD single membranes or 200 GPD Water Saver Systems The Aquatec...
www.bulkreefsupply.com
