Apex fusion and mp40

seeky007

Community Member
View Badges
Joined
Feb 17, 2024
Messages
93
Reaction score
43
Location
Bristol
Rating - 0%
0   0   0
Hi
I have a apex jr and a vortech mp40 connected using the mxm module I go in to the settings for flow set my desired daily flow upload it to the apex go to dash bord turn it on and it just goes to %100 no matter what I do so for thetime being I have switch back to using mobius any idea what I'm doing wrong?
 

boacvh

Valuable Member
View Badges
Joined
Aug 13, 2018
Messages
1,770
Reaction score
5,501
Location
SOCAL
Rating - 0%
0   0   0
Struggled with the same. Try setting it to auto, not on, that's how I did it on mine. On will make it 100%
 

Sisterlimonpot

Effortless Perfection
View Badges
Joined
Jul 15, 2009
Messages
4,260
Reaction score
8,615
Location
Litchfield Park
Rating - 0%
0   0   0
Thank you
As for your fallback question. I usually set the vortech fallback the same as what's set in fusion. That way if there is a communication issue with mxm the vortech won't skip a beat. The only downside is that you won't be able to have remote access to your mxm controlled devices until you fix the communication issue... which is usually a simple power cycle.
 
OP
OP
S

seeky007

Community Member
View Badges
Joined
Feb 17, 2024
Messages
93
Reaction score
43
Location
Bristol
Rating - 0%
0   0   0
As for your fallback question. I usually set the vortech fallback the same as what's set in fusion. That way if there is a communication issue with mxm the vortech won't skip a beat. The only downside is that you won't be able to have remote access to your mxm controlled devices until you fix the communication issue... which is usually a simple power cycle.
Thanks for that I will try it out later.
 

TOP 10 Trending Threads

Back
Top