jmatt
Just gettin' started. Again.
- Review score
- +0 /0 /-0
EPRA Member
Build Thread Contributor
- Joined
- Apr 27, 2022
- Messages
- 494
- Reaction score
- 703
- Review score
- +0 /0 /-0
- Location
- Lehigh Valley, PA
If I don't plug my COR20s into the EB832, can I still configure and monitor them via the aquabus cable?
I want the main return going directly to power, eliminating a fail point in the EB. I want the main return still pumping even if the EB stops functioning.
I have them set up standalone for the moment, running very low flow since the tank is only 106g and I have two COR20s. A few weeks back I plugged them into the EB and it seemed to take control and jack up the flow. I quickly disconnected since I'm still learning about the Apex.
I want the main return going directly to power, eliminating a fail point in the EB. I want the main return still pumping even if the EB stops functioning.
I have them set up standalone for the moment, running very low flow since the tank is only 106g and I have two COR20s. A few weeks back I plugged them into the EB and it seemed to take control and jack up the flow. I quickly disconnected since I'm still learning about the Apex.