Wiring Motorized Ball Valve

Stevorino

Well-Known Member
View Badges
Joined
Jul 14, 2014
Messages
571
Reaction score
535
Location
United States
Rating - 0%
0   0   0
I just received 4 of these motorized ball valves

I typically just get a plug from Home Depot and wire it into that, but I didn't know if there was a better/easier way to connect this to a plug to put into my Apex?
 
Last edited:
OP
OP
Stevorino

Stevorino

Well-Known Member
View Badges
Joined
Jul 14, 2014
Messages
571
Reaction score
535
Location
United States
Rating - 0%
0   0   0
That is BRILLIANT! Thank you for the link!

Do you have a recommendation for a housing where the two wires connect?
 

Zayne

Community Member
View Badges
Joined
Mar 20, 2020
Messages
42
Reaction score
18
Rating - 0%
0   0   0
That is BRILLIANT! Thank you for the link!

Do you have a recommendation for a housing where the two wires connect?
I don't have mine in any kind of housing - just soldered, wrapped with electrical tape and some heat shrink. I use mine for RO/DI shut offs in the basement, not really near open water/humidy.
 
OP
OP
Stevorino

Stevorino

Well-Known Member
View Badges
Joined
Jul 14, 2014
Messages
571
Reaction score
535
Location
United States
Rating - 0%
0   0   0
I don't have mine in any kind of housing - just soldered, wrapped with electrical tape and some heat shrink. I use mine for RO/DI shut offs in the basement, not really near open water/humidy.
Perfect- thanks so much!

I'm using mine for similar application. New RODI/Salt Reservoirs are hard to access and wanted the ability to just push go on Apex.

Thanks again!
 
Back
Top