Where to drill hole in stand for electrical wires?

[JoJosReef]

Looking for opinions. I need to drill a hole in the back of the stand to run the wires from wall outlets into the stand where the power strips will be mounted on the control board. Better to have the wires feed in from high? From low? Or from somewhere in the middle?

For reference, this is where the control board will be located:

Bricks will be cradled inbetween the pegboards, controllers, power strips and such will be on the front of the pegboard, as well as that dosing container. Trying to think what is best regarding entry of power cords. Happy to get ideas!

Thanks!

 

[Reefing_addiction]

Looking for opinions. I need to drill a hole in the back of the stand to run the wires from wall outlets into the stand where the power strips will be mounted on the control board. Better to have the wires feed in from high? From low? Or from somewhere in the middle?

For reference, this is where the control board will be located:

Bricks will be cradled inbetween the pegboards, controllers, power strips and such will be on the front of the pegboard, as well as that dosing container. Trying to think what is best regarding entry of power cords. Happy to get ideas!

Thanks!

I would probably drill holes directly behind where the bricks would be

 

[TangerineSpeedo]

In my electronics cabinet, I did a low and a high. Low in for power, High for outs, sensors, power to lights, fans etc.