I’m a little confused by a recent development in my Red Sea Reefer 170 setup. To give some backstory, I’ve been dosing Kalkwasser continuously with the use of a versa pump for about 2 months. I also do continuous auto-water changes with 2 versa pumps. 6 days ago, I increased my Kalk dosage from 0.2 mL/min to 0.25 mL/min because my alkalinity was dropping. I tested alk 48 hours after that adjustment to confirm that my alk stabilized, and it had.
I use an Apex ruler to monitor my ATO reservoir. I noticed that since I did that dose increase on the kalk, my ATO has not dispensed any water. I noticed today that the water level in the sump is higher than usual. I’d say it’s gone up about a half inch in 6 days.
I’m confused because from what I’m reading, my tank should be evaporating a minimum of 1.7 L (1% total volume) per day. The increased dose of Kalk should be adding 360 mL per day, a fraction of 1.7 L.
Is my tank really evaporating that little volume? Of note, I have calibrated all my versa pumps.
I use an Apex ruler to monitor my ATO reservoir. I noticed that since I did that dose increase on the kalk, my ATO has not dispensed any water. I noticed today that the water level in the sump is higher than usual. I’d say it’s gone up about a half inch in 6 days.
I’m confused because from what I’m reading, my tank should be evaporating a minimum of 1.7 L (1% total volume) per day. The increased dose of Kalk should be adding 360 mL per day, a fraction of 1.7 L.
Is my tank really evaporating that little volume? Of note, I have calibrated all my versa pumps.