since a few days im building my own reef pi build for my aquarium + vivarium. everything works fine but I can't get the sensors to show up on the temperature tab.
I checked if they show up by typing
pi@raspberrypi:~ $ ls /sys/bus/w1/devices/
and the respons shows 2 sensors and the usual bus check w1_bus_master1
the sensors showing up are the combined ones in the dht11 (temp and humidity)
but now back to the problem, I can't select them in the ui, they won't even show up in the dropdown. what did I do wrong, I enabled one wire in the config but every time I select it again it again asks me if I want to enable it. does this have anything to do with it?
I checked if they show up by typing
pi@raspberrypi:~ $ ls /sys/bus/w1/devices/
and the respons shows 2 sensors and the usual bus check w1_bus_master1
the sensors showing up are the combined ones in the dht11 (temp and humidity)
but now back to the problem, I can't select them in the ui, they won't even show up in the dropdown. what did I do wrong, I enabled one wire in the config but every time I select it again it again asks me if I want to enable it. does this have anything to do with it?
Last edited: