Hi
I have notice that the speed of pump 1 and 3 when using KH director runs very fast. This high-speed driving puts a lot of wear and tear on both the rollers and the pump hose. I would like to run these pumps a little bit slower. Can I use the pump settings for the pump (0,1,2, and 3) and/or the desired flow rate in order to slow down the pumps? I understand that the speed of pump 2 must totally be controlled by the KH director - my question concerns pump 1 and 3
Will this setting give me a half the speed of the pump function or has it no effect on the speed of the pump when KH director ask for filling or emptying - is the KH director totally in charge for the speed of the pumps or not? I´m aware that the test cycle will take much more time - but if I can lower the speed - then my reels and hoses will last so much longer (I hope)
@Gaël #ghlusers#KHDirector
Sincerely Lasse
I have notice that the speed of pump 1 and 3 when using KH director runs very fast. This high-speed driving puts a lot of wear and tear on both the rollers and the pump hose. I would like to run these pumps a little bit slower. Can I use the pump settings for the pump (0,1,2, and 3) and/or the desired flow rate in order to slow down the pumps? I understand that the speed of pump 2 must totally be controlled by the KH director - my question concerns pump 1 and 3
Will this setting give me a half the speed of the pump function or has it no effect on the speed of the pump when KH director ask for filling or emptying - is the KH director totally in charge for the speed of the pumps or not? I´m aware that the test cycle will take much more time - but if I can lower the speed - then my reels and hoses will last so much longer (I hope)
@Gaël #ghlusers#KHDirector
Sincerely Lasse
