Okay guys any suggestions would be much appreciated, so I’ve had this skimmer for about 2 months now and until the beginning of this week I’ve had no issue. 3 days ago I went to check on it and found the the level was dropping about an inch in the span of a couple second and would proceed to climb back to where it was only to drop again once it got there, I’ll attach the link to a video I have of it doing it.https://youtube.com/shorts/gesLfbd_Udo?feature=share
As for what I’ve done, the skimmer is a max spect jump sk series, I have pulled it apart, cleaned everything, used a toothbrush to clean both needle impellers, found a loose needle cap that was siliconed on and resiliconned it back in place to match the one on the other side, and checked to make sure the gate valve was secure, after doing all this I tried it again and it worked for a day and then started doing it again, I cleaned it again, double checked the silicon job, still secure and in place and checked the needle impellers for debris. All is okay. Is there anything I’m missing?
As for what I’ve done, the skimmer is a max spect jump sk series, I have pulled it apart, cleaned everything, used a toothbrush to clean both needle impellers, found a loose needle cap that was siliconed on and resiliconned it back in place to match the one on the other side, and checked to make sure the gate valve was secure, after doing all this I tried it again and it worked for a day and then started doing it again, I cleaned it again, double checked the silicon job, still secure and in place and checked the needle impellers for debris. All is okay. Is there anything I’m missing?