Pine Sol use by accident

Dr. Reef

www.drreefsquarantinedfish.com
View Badges
Joined
Jan 22, 2013
Messages
3,629
Reaction score
6,550
Location
Tulsa, OK
Rating - 0%
0   0   0
Hi Everyone
So we are in process of moving warehouses and in that one of my employee used pine sol to clean some tanks we took off the island to move.
They were dry but dirty and were getting ready to move to new warehouse to be installed there.
Now that couple of them have been in contact with pine sol. what should be the way to clean them to get rid of any bad left behind?
Should i clean these 2 tanks with bleach or soap or just rinse them very good?
Any help will be grately appreciated.
Thank you
Mike
 

Reef Wizard

Octopus Enthusiast
View Badges
Joined
Apr 1, 2022
Messages
1,224
Reaction score
3,178
Location
Middle TN
Rating - 0%
0   0   0
Hi Everyone
So we are in process of moving warehouses and in that one of my employee used pine sol to clean some tanks we took off the island to move.
They were dry but dirty and were getting ready to move to new warehouse to be installed there.
Now that couple of them have been in contact with pine sol. what should be the way to clean them to get rid of any bad left behind?
Should i clean these 2 tanks with bleach or soap or just rinse them very good?
Any help will be grately appreciated.
Thank you
Mike
I believe citric acid would likely get rid of it. Seems to be cleaner and easy on plastics and such other than white vinegar in my experience

I use it to clean my QT tanks

Lemi Shine Citric acid

Exact product I use no extra additives
 
Last edited:

Gribbles

Active Member
View Badges
Joined
Mar 10, 2022
Messages
481
Reaction score
387
Location
Cypress
Rating - 0%
0   0   0
I believe citric acid would likely get rid of it. Seems to be cleaner and easy on plastics and such than white vinegar in my experience

I use it to clean my QT tanks

Amazon product

Exact product I use no extra additives

Link is broken but I did find the product. Hopefully this works for others

Lemi Shine 100% Citric Acid 5 Pound Bag l Pure Food-Grade Flavor Enhancer & All-Natural Preservative | Fragrance Free Citric Acid for Bath Bombs, Cooking, & Canning https://a.co/d/ha9Wkoc
 

Marcus H.

Community Member
View Badges
Joined
Sep 4, 2024
Messages
29
Reaction score
42
Location
Texas
Rating - 0%
0   0   0

Reef Wizard

Octopus Enthusiast
View Badges
Joined
Apr 1, 2022
Messages
1,224
Reaction score
3,178
Location
Middle TN
Rating - 0%
0   0   0
Link is broken but I did find the product. Hopefully this works for others

Lemi Shine 100% Citric Acid 5 Pound Bag l Pure Food-Grade Flavor Enhancer & All-Natural Preservative | Fragrance Free Citric Acid for Bath Bombs, Cooking, & Canning https://a.co/d/ha9Wkoc
Thats it I tried fixing the link not sure what happened to it
 

vetteguy53081

Well known Member and monster tank lover
View Badges
Joined
Aug 11, 2013
Messages
96,707
Reaction score
215,505
Location
Wisconsin -
Rating - 100%
15   0   0
Hi Everyone
So we are in process of moving warehouses and in that one of my employee used pine sol to clean some tanks we took off the island to move.
They were dry but dirty and were getting ready to move to new warehouse to be installed there.
Now that couple of them have been in contact with pine sol. what should be the way to clean them to get rid of any bad left behind?
Should i clean these 2 tanks with bleach or soap or just rinse them very good?
Any help will be grately appreciated.
Thank you
Mike
Flush them with cold water to neutralize the pine sol and run the tanks with freshwater and a small nylon bag with lab grade carbon to further neutralize any chemical content. This often applies to vinegar and bleach use. If you can still smell it after all this - Caution !
Alternative is citric acid
 

Randy Holmes-Farley

Reef Chemist
View Badges
Joined
Sep 5, 2014
Messages
72,100
Reaction score
69,741
Location
Massachusetts, United States
Rating - 0%
0   0   0
The only things that are a concern in Pine Sol, IMO, are the surfactants. Those will be readily soluble in water so I would just rinse the tanks well and call it done.
 

Jay Hemdal

10K Club member
View Badges
Joined
Jul 31, 2020
Messages
28,604
Reaction score
28,261
Location
Dundee, MI
Rating - 0%
0   0   0
Hi Mike, I don't know, but I'm happy to keep this bumped for you. Maybe @vetteguy53081 @Jay Hemdal know what's best for removing residues and safest for fish?
I’ve never come across that happening, and I don’t like to guess about those sorts of things…

Here is another thread about pine sol though:
 

KrisReef

10K Club member
View Badges
Joined
May 15, 2018
Messages
15,227
Reaction score
31,279
Location
ADX Florence
Rating - 0%
0   0   0
So this is what is in Pine Sol. 8–12% pine oil, 3–7% alkyl alcohol ethoxylates, 1–5% sodium petroleum sulfonate and 1–5% isopropyl alcohol

I would rinse, wipe down with a rag of isopropyl alcohol, (to remove any remaining pine oil) and rinse again. If the smell is gone I would be confident to use the tanks. The MSDS did not say much.
This makes sense if the tanks are made of glass?

I don’t think that I would use isopropyl on plastic tanks, I would just use lots of water if the tanks were acrylic.

And posting so people looking for information can read about it now and later. Glass is not as reactive as plastic from chemical reactions we might normally encounter.
 
OP
OP
Dr. Reef

Dr. Reef

www.drreefsquarantinedfish.com
View Badges
Joined
Jan 22, 2013
Messages
3,629
Reaction score
6,550
Location
Tulsa, OK
Rating - 0%
0   0   0
Yes employee is an ex now, and tanks are glass. I think i am going to rinse them (just 2 tanks before i caught him) with bleach water and then rinse them out few times and let them air dry and go from there.
 

BeanAnimal

5000 Club Member
View Badges
Joined
Jul 16, 2009
Messages
5,071
Reaction score
8,108
Rating - 0%
0   0   0
Flush them with cold water to neutralize the pine sol and run the tanks with freshwater
Cold water is of no use, hot if anything but neither are a solvent for pine oil. Cold increasing the viscosity and hot decreasing it....

Organic solvents (citric acid for example) can dissolve it.
 

vetteguy53081

Well known Member and monster tank lover
View Badges
Joined
Aug 11, 2013
Messages
96,707
Reaction score
215,505
Location
Wisconsin -
Rating - 100%
15   0   0
Cold water is of no use, hot if anything but neither are a solvent for pine oil. Cold increasing the viscosity and hot decreasing it....

Organic solvents (citric acid for example) can dissolve it.
No hot water with silicone as it can soften silicone and according to reps at chemipure, cold water neutralizes bleach, vinegar and many household cleaners which contain alcohol and other soluble liquids such as surficant #3. As stated by Randy, water should alone dissolve this. I go by what others have found successful and more than once have I seen water itself work. I did mention citric although im reluctant with tank versus rock, but find it safe
 

Randy Holmes-Farley

Reef Chemist
View Badges
Joined
Sep 5, 2014
Messages
72,100
Reaction score
69,741
Location
Massachusetts, United States
Rating - 0%
0   0   0
Cold water is of no use, hot if anything but neither are a solvent for pine oil. Cold increasing the viscosity and hot decreasing it....

Organic solvents (citric acid for example) can dissolve it.

The oil is present with lots of surfactants to dissolve it.
 

BeanAnimal

5000 Club Member
View Badges
Joined
Jul 16, 2009
Messages
5,071
Reaction score
8,108
Rating - 0%
0   0   0
No hot water with silicone as it can soften silicone and according to reps at chemipure,
I suppose it depends on what you consider “hot” and how long the exposure is :)

The suggestion is not to fill the aquarium with boiling water, let alone maintain it that way. Using warm or “hot” water (say 140F) to rinse a silicone and glass aquarium will do no harm.

Thermal expansion is extremely low (joint integrity) and typical silicone sealant does not begin to degrade until around 392F. Prolonged exposure at 200F and above does speed aging. Sorry, but well intentioned anecdote and materials science sometimes don’t match. Nobody is going to damage their silicone and glass aquarium using hot tap water, needed or not.


cold water neutralizes bleach,
Cold water doesn’t neutralize bleach; it just slows its chemical activity, while warm water speeds it up. Both hot and cold water will dilute bleach.

In fact, “neutralization”…. I think that around 77F bleach begins to (slowly as in days or months) decompose and that process speeds up as temperature rises. At 140F, degradation rate is pretty high (sorry too lazy to look but more like hours).


Yes.. I get stuck on facts, but you know me and topics like this :)
 
Last edited:

BeanAnimal

5000 Club Member
View Badges
Joined
Jul 16, 2009
Messages
5,071
Reaction score
8,108
Rating - 0%
0   0   0
Ohh and back in the 80s I was a vert skater, and once I washed my very stinky pads in mix of pinesol and Murphy’s oil soap… and they forever smelled like that even after rinsing a dozen times. It was terrible on hot days. Worst part is the knee pads were custom made (flap jax ) and super expensive back then. :zany-face:
 

Jay Hemdal

10K Club member
View Badges
Joined
Jul 31, 2020
Messages
28,604
Reaction score
28,261
Location
Dundee, MI
Rating - 0%
0   0   0
Ohh and back in the 80s I was a vert skater, and once I washed my very stinky pads in mix of pinesol and Murphy’s oil soap… and they forever smelled like that even after rinsing a dozen times. It was terrible on hot days. Worst part is the knee pads were custom made (flap jax ) and super expensive back then. :zany-face:

I have a swimsuit that got exposed to high bromine in our hot tub. A year later it still smells, despite washing it. I just do without now…
 
Back
Top