Hi guys,
This is my first post here . Excited to be a part of the community.
This evo is my first saltwater tank in about 10 years. I just got cycled, did a large water change and am ordering fish tomorrow!
I haven't installed my skimmer yet, but I moved my m50 heater to the return chamber in preparation for it.
The heater just barely touches the top side corner of the return pump. I cut out a square of the cover so it didn't touch any more than this. It sticks out of the top a bit but still is covered past the minimum water line.
Will this very minimal touching of the return pump be a problem?
My pump is too big to accommodate the heater in that chamber too, without touching just a little.
Anyone else have similar problem? Is it ok?
This is my first post here . Excited to be a part of the community.
This evo is my first saltwater tank in about 10 years. I just got cycled, did a large water change and am ordering fish tomorrow!
I haven't installed my skimmer yet, but I moved my m50 heater to the return chamber in preparation for it.
The heater just barely touches the top side corner of the return pump. I cut out a square of the cover so it didn't touch any more than this. It sticks out of the top a bit but still is covered past the minimum water line.
Will this very minimal touching of the return pump be a problem?
My pump is too big to accommodate the heater in that chamber too, without touching just a little.
Anyone else have similar problem? Is it ok?