Hello,
I have two MP10's and just one controller. I willing to connect both pumps to same controller making jumpers into the board connector, so I would be able to plug both motors to the same controller. In parallel this i will change the 24V 1.5A for a 24v 3A power supply.
I expect the both motors act exactly the same way. I had this experience in the past plugging Stepper motors in parallel (Vortech's uses stepper motors).
The big question here is: Will the driver be overload at full power?
Does anyone tried this before?
Thanks in advance.
Att,
C. Oliveira
I have two MP10's and just one controller. I willing to connect both pumps to same controller making jumpers into the board connector, so I would be able to plug both motors to the same controller. In parallel this i will change the 24V 1.5A for a 24v 3A power supply.
I expect the both motors act exactly the same way. I had this experience in the past plugging Stepper motors in parallel (Vortech's uses stepper motors).
The big question here is: Will the driver be overload at full power?
Does anyone tried this before?
Thanks in advance.
Att,
C. Oliveira