I'm trying to figure out the settings to perform a 25 gallon water change profile that I will add to my AWC DOS pump head configuration.
This is my current DOS_ADD configuration
Fallback OFF
tdata 08:00:00,1,18,3,133,2,88,84,3,157,0,0,10,0
If KILL CLOSED Then OFF
If H2O CLOSED Then OFF
If MIX-LO OPEN Then OFF
Min Time 001:00 Then OFF
I want to add the following commands for when I want to do a 25 gallon water change, but I'm struggling with understanding the math for the "dose" profile.
If FeedD 0000 Then WC-ADD
If FeedD 0000 Then WC-REMOVE
This is what I came up with, but not sure if it is correct.
This should dose 93,000 mL (about 25 gallons) in 23 1/4 hrs.
Does that sound about right, or am I totally wrong? I can't find any information about this anywhere, so I'm thinking that I'm way off base.
Thoughts?
This is my current DOS_ADD configuration
Fallback OFF
tdata 08:00:00,1,18,3,133,2,88,84,3,157,0,0,10,0
If KILL CLOSED Then OFF
If H2O CLOSED Then OFF
If MIX-LO OPEN Then OFF
Min Time 001:00 Then OFF
I want to add the following commands for when I want to do a 25 gallon water change, but I'm struggling with understanding the math for the "dose" profile.
If FeedD 0000 Then WC-ADD
If FeedD 0000 Then WC-REMOVE
This is what I came up with, but not sure if it is correct.
This should dose 93,000 mL (about 25 gallons) in 23 1/4 hrs.
Does that sound about right, or am I totally wrong? I can't find any information about this anywhere, so I'm thinking that I'm way off base.
Thoughts?