So I was a bit bored at work and was like hey let’s build something I figured why not better than dying of boredom..
I found a few pieces of acrylic and decided to make a “prototype” AIO.. about 15 minutes later coming off a laser cutter and some weld-on
Go ahead and critique it I know some of the pieces are not plumb but that’s just aesthetics.
After waiting 72 hours for the acrylic to fully cure, I water tested. With it full I do not have any sides that are bowing which is promising.
No leaks I’m going to see what I’m dealing with tomorrow, granted I used scalding hot water to test the seams as a factor for design failure.
I will update later this week
I found a few pieces of acrylic and decided to make a “prototype” AIO.. about 15 minutes later coming off a laser cutter and some weld-on
Go ahead and critique it I know some of the pieces are not plumb but that’s just aesthetics.
After waiting 72 hours for the acrylic to fully cure, I water tested. With it full I do not have any sides that are bowing which is promising.
No leaks I’m going to see what I’m dealing with tomorrow, granted I used scalding hot water to test the seams as a factor for design failure.
I will update later this week