Converting bubble magus arf-m g2 Roller Filter to accept Dual Drains

[rich99uk]

Good Afternoon all. I have purchased the bubble magus arf-m g2 Roller Filter and would like to adapt it to take two drains. I have 3D printed the Bulkhead adaptor from previous posts. Has anyone used this mod before. I can remove the blanking plate the other side to install it but that also removes the tube attached where the water filters down. Is that an issue Part in question is the water inlet pipe as seen below. Thanks in advance

 

[Gumbies R Us]

Bumping your post!

 

[rich99uk]

Just wanted to update in case someone has same issue I successfuly converted to use with x2 drains 3D printed plate and used fitting from local hardware store.