I was working in my cabinet today and noticed that my power bricks for my Hydras are running quite hot.
This made me wonder….. could I solve the heat issue and end up with one power cable for both lights rather than two?
the power brick on my hydra reads:
AC input: 100-240v 2.5A
DC output: 36V 2.5A
could I simply buy, say a 100-240v 10 amp power supply and run both lights from it with a splitter? That way the power brick wouldn’t be as hot as it’s not running near capacity? And then as a side benefit narrow it down to one plug taken up on my power bar?
This made me wonder….. could I solve the heat issue and end up with one power cable for both lights rather than two?
the power brick on my hydra reads:
AC input: 100-240v 2.5A
DC output: 36V 2.5A
could I simply buy, say a 100-240v 10 amp power supply and run both lights from it with a splitter? That way the power brick wouldn’t be as hot as it’s not running near capacity? And then as a side benefit narrow it down to one plug taken up on my power bar?