Apex Inkbird alarm

[TWYOUNG]

Can anyone tell me what the following alarm I keep getting from Apex regarding my Inkbird ITC-306T-WIFI? INKBIRD-2 A is less than 0.1(0.0)

 

[Dburr1014]

Can anyone tell me what the following alarm I keep getting from Apex regarding my Inkbird ITC-306T-WIFI? INKBIRD-2 A is less than 0.1(0.0)

Can you post your settings from apex for that outlet?
"A" suggest amperage me thinks.

 

[TWYOUNG]

Can you post your settings from apex for that outlet?
"A" suggest amperage me thinks.

 

[Dburr1014]

This is why the alarm is happening.
You are going below the value.

 

[TWYOUNG]

Can you post your settings from apex for that outlet?
"A" suggest amperage me thinks.

I changed that minimum 0.1 to 0.0 to see it that stops it but I'm not sure what that means, or if it was okay to do.

 

[Dburr1014]

I changed that minimum 0.1 to 0.0 to see it that stops it but I'm not sure what that means, or if it was okay to do.

A is amps, heater shuts off and no more 0.1 amps on that outlet.

 

[TWYOUNG]

A is amps, heater shuts off and no more 0.1 amps on that outlet.

Now outlet is shutting off unless switch is changed from auto to on. Did I cause that and how do I fix it. How many amps should I be allowing on that outlet. Inkbird has two 300W heaters and has been running that way for 7 months. Attached is the current programming for that outlet.

 

[Dburr1014]

Now outlet is shutting off unless switch is changed from auto to on. Did I cause that and how do I fix it. How many amps should I be allowing on that outlet. Inkbird has two 300W heaters and has been running that way for 7 months. Attached is the current programming for that outlet.

What is in here?




Fallback is if apex loses communication.
Fallback should be on also.

To be honest, mine is only set in temp on the outlet. Not sure why yours is set as watts and amps also. For failure maybe?

 

[TWYOUNG]

What is in here?

View attachment 2980635


Fallback is if apex loses communication.
Fallback should be on also. View attachment 2980646

To be honest, mine is only set in temp on the outlet. Not sure why yours is set as watts and amps also. For failure maybe?

This is whats under the advanced tab

 

[Dburr1014]

Alright, I'm assuming you have clicked on the heater tab for control type.
I use the advance tab. Now I control when the heater comes on and off. I also have it turn off if there is a leak.

If you don't want to do that, can you type in 0.01 where the 0.1 was?