Apex ATO Coding Question

[AbominableBro]

I have a quick question about the Apex ATO kit.
The pump for the ATO was auto programmed through the task function online. My question is regarding the Output configuration. Is there suppose to be a separate set of advanced coding under the aquabus? I can't figure out of the coding was automatically upload during the initial configuration or if I added it one night while drunk by accident. I attached a screen shot below.
I appreciate any help.

 

[ihavecrabs]

Drinking in excess while reefing is not recommended I have seen a few people lead their tank to disaster doing so ;Wideyed

Here is my program:

Fallback OFF
Set OFF
If Swx10_1 OPEN Then ON
If Swx10_2 CLOSED Then OFF
If Power Apex Off 005 Then OFF
When On > 005:00 Then OFF
Defer 000:15 Then ON
Defer 000:15 Then OFF
Min Time 060:00 Then OFF

 

[AbominableBro]

Drinking in excess while reefing is not recommended I have seen a few people lead their tank to disaster doing so ;Wideyed

Here is my program:

Fallback OFF
Set OFF
If Swx10_1 OPEN Then ON
If Swx10_2 CLOSED Then OFF
If Power Apex Off 005 Then OFF
When On > 005:00 Then OFF
Defer 000:15 Then ON
Defer 000:15 Then OFF
Min Time 060:00 Then OFF

thank you!

 

[jml1149]

Something is amiss here.

As long as you plugged your PMUP into the FMM, and the FMM 24VDC adapter also into a wall outlet, then there's no reason that you should have ATO code in an EB8 outlet. This is what my ATK code looks like, attached. You see on the left, it says:

Location


24V Accessory Output on the FMM named FMM_6 at Aquabus address 6.


Your ATK code should live in an Output Configuration tied to the FMM as well. Note my code is tweaked a bit from the task setup, but I used the task to set this up as well. But the core is the same.