leveling

Is this ok? It’s slightly overhanging from the mat. It’s a 25g aio tank. Completely level.

Hello, I filled my tank with water and noticed the water line is not level (the front right corner is much higher than the higher three, and the back left corner is the lowest) I believe it is due to the floor/house. Can someone please recommend me a way to fix this?

Hello everyone , I am keeping my new 90l aquarium under two cabinets, however it is extremely uneven I think it's because of the floor. Would you say that it's better to keep the tank on one cabinet and focus on levelling it as it may be too difficult to level both of the cabinets together as...

The initial spot I wanted to put my Waterbox 180.5 turned out to be too unlevel for the provided leveling feet to compensate for so I decided to wait until we renovated another room to setup the tank. I actually ended up having the same issue with uneven flooring in the next room (the house...

Hello, I am currently planning a new build. I attached a picture of a mock up of my build. The tank will be a peninsula 60x36x24 (210 gallons, water weight 2500 lbs) steel stand (680lbs), canopy (120 lbs). With rocks, sand, equipment etc. I am estimating a total weight of around 4000lbs...

We’re setting up a new RSR XXL 750 which is almost a 6’ tank. I got the tank painstakingly leveled, threw in the sump and plumbing, and was getting ready to fill when I decided to do a paper test. It initially showed I could slip a full piece of paper in at multiple points on the left and front...

I am having a difficult time leveling my new Waterbox REEF 180.5. The tile in my living room is not consistent/level and it was laid on a concrete foundation. This is the back left of the tank: This is the front right (it actually comes off the threading to reach the floor so I am trying to...

Don’t y’all hate when you’re floor isn’t level and now you have to drain your qt and move it to a stand you’ve been using for storage. smh

Hey guys I have a 32 galllon biocube and the coralife stand with it. Now I set everything up and have it placed on hardwood floor but first my stand had a little wobble as far as I can tell it’s from the floor if I bring it out from the wall it doesn’t wobble nearly as much but I can’t just...

Ok so my last biocube cracked. I think it was because the tank wasn’t level. I set the new one up and the stand was level before I put the tank on. It’s on hardwood. I leveled the stand using plastic shims. The tank is now 1/8” out of level diagonally. Should I be worried about it cracking again?

Hey guys. Getting a new biocube after my old 32 led cracked on me. Do I need to use a self leveling mat or are they not worth the money? Not really sure why the old one cracked and I’m trying to prevent it from happening again.

Morning Everyone, So I have run into an issue with my tank. I ended up getting this off Craiglist and everything looked fine. It is a 180 gallon reef ready with a twist, the bottom panel is a PVC like material with a plywood backing (photographs to follow) I resealed the tank and built the...