Hello,
Recently, my jebao dcp-5000 pump have started working very strangely. It works normally up to 40% power. When I set it above 40%, I can see on the screen that power increases but after reaching this 40% power level, it drops back to zero and this reapeats itself endlessly. No error code...
I just bought a second jebao mlw-20 and put it in master/slave modes, but the master for the slave changes only the modes according to the schedule, but not the speed, and when the slave is configured, this parameter is constantly adjusted. Then what is the point of doing master/slave modes, if...
Hi my tank is 30inches in width 10inches deep and 10 inches tall .
As you can see from the picture I have one 40watt wavemaker on the left.
I’m asking for recommendations whether I should get another one on the opposite side will it be beneficial?or just a waste of money because I have my...
Does anyone know what the dial does on the bottom of this Jebao Controller? Also, I don’t understand what’s the difference between the speed settings and that dial. Read over the manual and it didn’t have much explaining about what the dial does.
SO I want to add bubble tips to the 55 gallon tank. and like some feedback on a powerhead under 100 bucks. (or so)
The tank is tied to my 220gal sys.
this is what I was looking at? With the PP8's you get 2 pumps? advice plz, want to buy...
Figured I'd share this here as well. I used 1/2 inch veranda PVC trim to construct the false wall and wave box on our upcoming 75 gallon display. I used mortise joints for added strength and to provide a channel for the PVC solvent cement. The internal dimensions came out to be roughly...